Basic Hand Tools Required 

Taken: Feb 2, 2012

808 #11 / #16 Factory Fitted Lens 

Taken: Feb 2, 2012

Suitable Materials around 1.5mm thick 

Taken: Feb 2, 2012

Roughy cut 2 x 2 inch square 

Taken: Feb 2, 2012

Trimming the backplate down to size 

Taken: Feb 2, 2012

Marking out the centre point on the plate 

Taken: Feb 2, 2012

Using a pin to mark the hole centre 

Taken: Feb 2, 2012

Making a pilot hole in the backplate 

Taken: Feb 2, 2012

Reaming out the centre hole to size 

Taken: Feb 2, 2012

Finished backplate with hole cut to size 

Taken: Feb 2, 2012

CMOS module fitted - rear view 

Taken: Feb 2, 2012

CMOS module fitted - side view 

Taken: Feb 2, 2012

Modifying the 'stock' M12 lens holder 

Taken: Feb 2, 2012

Scoring a line to mark the cut 

Taken: Feb 2, 2012

Near enough :) 

Taken: Feb 2, 2012

Sides removed 

Taken: Feb 2, 2012

Sanding the base smooth 

Taken: Feb 2, 2012

Modified M12 adaptor - top view 

Taken: Feb 2, 2012

Modified M12 adaptor - bottom view 

Taken: Feb 2, 2012

Choosing the correct adhesive 

Taken: Feb 2, 2012

Waiting time.... 

Taken: Feb 2, 2012

Finished M12 adaptor - top view 

Taken: Feb 2, 2012

Finished M12 adaptor - bottom view 

Taken: Feb 2, 2012

Rear view with CMOS module fitted 

Taken: Feb 2, 2012